We can't help everyone, but everyone can help someone. Ronald Reagan
Idea Transcript
Posted on December 4, 2012 by Larry McDowell Leave a comment
Problem: Acquired a used Adtran 3450 router and needed to configure it for a location that needed a router. Problem was that I didn’t know the password for the web user, enable and the console user. I needed to find a way to reset this router or change the password. Solution: To get into the router and bypass the passwords, you need to console into the router using a DB9 serial cable and a VT100 emulator like Putty or HyperTerminal. When connected, pres ESC within the first 5 seconds of the unit powering on to get into bootstrap mode. Once in bootstrap mode, type bypass passwords and press enter. Then type boot and the unit will reboot, bypassing the need for passwords.
Windows 7 wireless. Connected but local access only Could not synchronize record: Outlook 2011 for Mac Domain Admin can login to OWA but regular users cannot Free CD Burning Software: CDBurnerXP Delete contacts on iPhone
2.0 3g active directory apple Astaro backup
Chrome contacts delete email
browsers
Reset Password: 1. At the # prompt type config terminal and press Enter. 2. At the (config)# prompt, type enable password password Where password is your new password. 3. At the (config)# prompt, type username youruser password yourpassword and click enter. Of course yourmuser and Your password are the user and password that you choose. This will create a new administrator user where you can login without going into bootstrap mode. 4. Type exit and the write mem to save the config.
iPhone microsoft outlook outlook 2010 owa pandora plugins proxy retrospect server 2008 service pack sophos sync update
upgrade Vista web design windows
windows 7 windows 10 windows update
Set the IP address to Eth1: 1. At the # prompt, type config terminal and press enter 2. At the (config)# prompt, type interface eth 0/1 3. Enter ip address 10.0.0.1 255.255.255.0 (Put your desired IP address instead of the 10.0.0.1 supplied above.) 4. Type exit and the write mem to save the config.
wordpress Shop Related Products
Make sure HTTP access is turned on: 1. At the # prompt, type config terminal and press enter 2. at the (config)# prompt type ip http server and press enter 3. Type exit and the write mem to save the config
Adtran Netvanta 3120 Fixed-port Router $285.00
After you turn on HTTPS access, you can do all the other configuration via the web browser which is much easier.